Data send request not working

[dle]

Hi,

I am trying to set up the trial version of the serial data logger to retrieve data from some Vaisala monitors. The request command is SEND 10\r.

I have set up the send command in the ASCII data query and parser module to be sent every 5 seconds, this is displayed in the data window but no data is returned from the monitors. I have also tried converting the \r of the command to ASCII codes but there is still no data returned.

If I set the vaisala monitors to a run mode to send out data every 5 seconds then the data is received by the serial data logger and displayed in the window so I know that the serial port is set up correctly. I have also used a different program (DasyLab) to send out the data request and this will work and the data is returned from the monitors.

Kind regards

Donald

[Arthur Grasin]

Please, specify your request as:

SEND 10#0A

where #0A will be converter to a byte with 0x0A hexadecimal code

\r => LF => 10d => 0Ah => #0A

[dle]

Thanks for the reply Arthur,

It actually needed #0D at the end to get it to work so I assume the \r equates to CR but your response sent me in the right direction.

Kind regards

Donald