AGG Software Forums
February 21, 2019, 01:09:40 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Welcome on our forum!
 
   Home   Help Search Login Register  

Pages: [1]
  Print  
Author Topic: Settings required for Air Liquide Digisaf 510 (Burny 10 LCD)  (Read 9151 times)
GerardLardner
Newbie
*

Karma: +0/-0
Posts: 1


View Profile
« on: September 16, 2011, 06:33:37 PM »

Can anyone advise the appropriate settings for use with a Burny 10 LCD controller?

We have an Air Liquide Digisaf 510 plasma cutter, which uses the Burny 10 LCD controller. I have installed an RS232 link back to a PC in the workshop office (Windows XP SP3, running a trial of DNC Precision). But I cannot get a drawing to load from the PC to the plasma machine, either with DNC Precision in server mode or in manual mode.

I have checked the RS232 link in both directions using a loopback plug. It works. I works both with the loopback plug at the PC end and using the Serial Test function on the Burny, and with the loopback plug at the Burny end and using a test program from the PC. So I guess I haven't found the correct settings.

Anyone else got DNC Precision to work with a Burny 10 LCD?
Logged
Arthur Grasin
Tech. Support
Administrator
Hero Member
*****

Karma: +0/-0
Posts: 762



View Profile WWW
« Reply #1 on: December 05, 2014, 11:00:00 AM »

Please, try to open the Hex window and receive data from the machine. It you'll not see any data, then the link is broken.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines