AGG Software Forums
November 22, 2024, 07:45:47 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Welcome on our forum!
 
   Home   Help Search Login Register  

Pages: [1]
« previous next »
  Print  
Author Topic: Serial Print Logger and a Parallel (centronics) Dot-Matrix printer  (Read 39720 times)
saddx
Newbie
*

Karma: +0/-0
Posts: 2


View Profile
« on: December 12, 2010, 11:00:00 AM »
Is it possible to use Serial Print Logger to replace my old dot-matrix centronics printers? I have purchased a Parallel to RS232 Converter to connect the printer cable to a serial port on another computer. If possible how does one control the handshaking so the sending device doesn't report out of paper.
Logged
Arthur Grasin
Tech. Support
Administrator
Hero Member
*****

Karma: +0/-0
Posts: 806



View Profile WWW
« Reply #1 on: December 23, 2010, 11:00:00 AM »
Usually, this method works without any problems. Please, refer to a manual for your device. It is possible you should not use hardware flow control on the PC side. In any case you may disconnect a corresponding wire from the centronics cable and and may be ground it.
Logged
saddx
Newbie
*

Karma: +0/-0
Posts: 2


View Profile
« Reply #2 on: December 21, 2010, 11:00:00 AM »
Thank you, I was able to get it to work.
Logged
Pages: [1]
  Print  
« previous next »
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines