Hi,
I'm working with advanced serial datalogger 3.7.2, I configured datalogger as serial machine configuration
checkweigher coms settings:
code: ascii
stop bits: 1
parity check: off
baud rate: 9600
settings in software:
code:ascii
data bits: 8
parity: none
stop bits:1
datalogger is working well, but suddenly it stoped an closed. When it was opened again, datalogger was clean while checkweigher was sending data.
Then I paused receiving data, then I play it again, it appeared the UART receiver framming error on buttom area.
When I changed configuration to stop bits=2, I got code 96# and noise data, so I got back to original configuration stop bits = 1, since data are getting well.
This has been happened frequently, about 3 or 4 times on last 5 days, I haven't found cause yet
Are you using an USB-to-Serial converter?