|
Title: Two extra line feeds for each line sent Post by: mauricedm on August 12, 2009, 07:45:45 PM I have an Fanuc M10 controler on a Mori Seki MV45/40. After installing the program I can send to the machine just fine. But when I recieve someone addes two blank lines after each line. The machine only has three setting Buad rate, Stop bits, and DC codes. MY settings are 7 data 2 stop 4800 baud Software flow control. Have tried changing dc codes all modes and it made no difference. Changed the software to ignore blank lines in sending recieving and both to no avail. Anyone have any ideas.
Thanks Title: Re: Two extra line feeds for each line sent Post by: Arthur Grasin on April 08, 2011, 10:00:00 AM It is necessary to detect line feed characters that use the controller. Could you create binary log file and attach it here? You may also try to specify #0D#0A#0A in the "Line end" field on the "Format - Data exchange" page.
|