|
Title: Files do not transfer completely to CNC machine Post by: aprecision on January 20, 2010, 09:07:11 PM I'm having an issue with the trial version of DNC Precision. When I send a file to the Haas CNC control, it is completely empty at the control. I've tried adjusting the starting and ending character parameters in DNC Precision, but this didn't have any effect. Other DNC software, such as Multi-DNC and MultiLink, work just fine. Is there anything I'm missing?
Title: Re: Files do not transfer completely to CNC machine Post by: Arthur Grasin on April 06, 2012, 10:00:00 AM Please, try to receive from the machine first. If this will work properly, then program should send to the machine with same settings.
Title: Re: Files do not transfer completely to CNC machine Post by: chaos on March 05, 2010, 01:59:13 AM I'm having the same issue. The DNC program will receive just fine, but when sending, part of the info is missing. :'(
Title: Re: Files do not transfer completely to CNC machine Post by: Arthur Grasin on March 08, 2010, 10:35:47 AM Please, send your controller model name to our support team via email with the file that you can receive. It is possible you need to adjust your settings.
Title: Re: Files do not transfer completely to CNC machine Post by: darrylsaladino on July 23, 2013, 10:00:00 AM This is one of the most commonly asked questions. All we can say is that if your CNC supports the RS232 protocol, then yes it will. We even supply a list of predefined CNC templates to get you started for many popular machines. We do not support exotic proprietory protocols that are outside the scope of RS232, such as LSV2, Fidia etc.
|