Hello
I have a machine with a FANUC OT controller. I cannot use brackets as that option on this machine is not turned on.
when i send a file from the NC to the PC the PC responds but then hangs with the message along the bottom.
Waiting for end of file.
Please what am i missing
Malcolm
Also is this normal
The status line on the bottom is cycling through these things every 5 seconds
Waiting NC commands
Waiting NC commands
Waiting for the transmitter ready
Ready!
Waiting for the start of the file
and then in red
Can't receive a sigh of the start of a file
And round it goes again,
Quote
The status line on the bottom is cycling through these things every 5 seconds
Yes this is normal.
Please, verify that you use data exchange settings from the attached screenshot.
If it doesn't work, then please, activate binary log files (Serial port - Logging) and attach these files here. Binary log files will be located in a folder that you can specify here: Main menu - Options - Configure - Logging