The control is Fanuc 0i-T.
No problem transefring file from lathe to pc (exept loosing % at program ends).
When transfering from pc to lathe, an allarm generated.
Any suggestions?
1. Please, open the "Transferred data" window. Right-click over the machine in the list and select the "Show transferred data" menu item.
2. Try to receive a small program from the machine
3. Attach a screenshot with received data.
Attached please find required screenshot.
The problem is only with sending file from pc to machine.
Thanks,
Ran
Please, expand the window and make the full screenshot.
OK
Please, try the following settings:
Now no alarm appears, but LSK keeps blinking on the control's display.
Attached the file of transfered data screenshot.
It seems that your program already contains % characters at the end. In this case, please, enable the "starting/ending characters stored in the file" options.
Sorry, no change
Please, try to send a very small program (just 2-3 lines) from the machine and attach the window with whole program. It is possible we should modify a header.
OK, here it is
Please, change the following settings. The "program begin" option contains a space between % and #0D.
Sorry, no change. LSK keeps blinking on the control's display.
Attached the file of transfered data screenshot.
You've attached the screenshot when you've transferred data from the computer to the machine. I need a screenshot when you'll transfer data from the machine to the computer. Please, a very small program from the machine. In this case I can see the format of data that uses your machine.
OK, attached.
Attached also: Receive Data Exchange.
(Receiving is going with no problems)
Please, try the following. Please, note that #0A this is #, zero, A
Arthur, thanks a lot for your consistent support!
Now both transmit and receive are working good.
Best Regards,
Ran Yadin
Head CNC Programmer
Ricor Cryogenic & Vacuum Systems
Mail: tibam@ricor.com
Phone: 972-4-6530866
Mobile: 972-52-6027395
Fax: 972-4-6532424