Print Page - Wrong setting? Unrecognizable characters

Title: Wrong setting? Unrecognizable characters
Post by: Ricks on April 13, 2011, 05:45:24 PM

Based on the example below, is there a proper setting I can adjust so that the unrecognizable characters become recognizable? Examples: á¨ Á" Áœ

Thanks,
Rick

<20110413123529.696 TX>
Z<ENQ> <SOH><STX><NUL><HT>á¨
<20110413123529.711 RX>
Z<SOH><ENQ>Á"
<20110413123529.743 TX>
Z<SOH><DC1>ÁœZ<SOH>!Áˆ
<20110413123529.758 RX>
Z<RS><DC2><SI><ETX><STX><STX>-<NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL><NUL>´cZ<SOH><ENQ>Á"
<20110413123535.540 TX>
Z<ENQ> <SOH><STX><NUL><HT>á¨Z<SOH><DC3>@]Z<SOH>!Áˆ
<20110413123535.571 RX>
Z<SOH><ENQ>Á"Z<DC1><DC4><SOH><VT><EOT><CR> [len=55]
<20110413123535.586 RX>
<ETX><FF>#!<SOH><ACK><BEL><DC3><SYN>ë<NUL><NUL>‡Z<SOH><ENQ>Á"

Title: Re: Wrong setting? Unrecognizable characters
Post by: Arthur Grasin on April 13, 2011, 06:40:40 PM

It seems that these characters with an ASCII code >= 0x80. You can change the corresponding options here: Main menu - Options - Program settings - View mode - Data view.

Title: Re: Wrong setting? Unrecognizable characters
Post by: Ricks on April 14, 2011, 02:09:09 AM

AHA!!!

Thanks Arthur. Missed that.

Rick

AGG Software Forums

Online Help Center => Advanced Serial Port Monitor => Topic started by: Ricks on April 13, 2011, 05:45:24 PM