|
Title: Koike Aronson Hybrid D11 plasma cutting Post by: jeanseville on July 10, 2011, 03:32:18 PM Trying to bring up a failed system. The Window 95 software's hard drive failed. Was able to reload software from CDs but don't know the "protocol" expected by this particular logic controller that's mounted on the plasma cutting table . I see it referred in 2 ways in the brief installation manual... a Creonics Hybrid- D11 or a Westinghouse Hybrid D11. Would appreciate any help in learning more about this.
The hardware is a five hour drive away and would like to be prepared when I hook it up. jeanseville houston texas |