|
Title: Settings required for Air Liquide Digisaf 510 (Burny 10 LCD) Post by: GerardLardner on September 16, 2011, 06:33:37 PM Can anyone advise the appropriate settings for use with a Burny 10 LCD controller?
We have an Air Liquide Digisaf 510 plasma cutter, which uses the Burny 10 LCD controller. I have installed an RS232 link back to a PC in the workshop office (Windows XP SP3, running a trial of DNC Precision). But I cannot get a drawing to load from the PC to the plasma machine, either with DNC Precision in server mode or in manual mode. I have checked the RS232 link in both directions using a loopback plug. It works. I works both with the loopback plug at the PC end and using the Serial Test function on the Burny, and with the loopback plug at the Burny end and using a test program from the PC. So I guess I haven't found the correct settings. Anyone else got DNC Precision to work with a Burny 10 LCD? Title: Re: Settings required for Air Liquide Digisaf 510 (Burny 10 LCD) Post by: Arthur Grasin on December 05, 2014, 11:00:00 AM Please, try to open the Hex window and receive data from the machine. It you'll not see any data, then the link is broken.
|