I am confused. First people connect them all the time. I connect to the A port with a serial cable and load small files into my machine all the time but not DNC as yet. The Bridgeport Boss mills do not have the common serial ports that you find on every computer. My question is this. What type of connection and how do people use your program to communicate with the Boss 8?
Steve

I got it to accept files by un-checking the box that prohibited from loading files from other directories. I am getting the error message and I am concerned about the Serial Cable. It is a standard 9 pin serial port on the computer and on the mill it is an 8 port  RS-422 which the manual says has built in Dnc loading. What pin arrangement to pin arrangement  should it have?

Steve

I do appreciate your prompt reply. I found Options->Manual mode->Directories and files->File extensions and added .txt. I closed the program and opened it again and the changes remained. I can see in the DNC directory the .txt file but when I go to Transmit and click .txt there is nothing there. When I click show all files it only shows the one .nc file. I tried saving it at the bottom of the DNC screen to the ini file but I could not find an option to use it. I have used notepad to try to save the little test file you sent but it does not show up either.
Steve

I can copy files into the DNC folder but I do not see them when I want to transmit a G code file. I think it wants an .nc file extension, VisualCam posts a .txt file.

1) Can a .txt file be used? Can a .txt file be converted?

2) When I transmit the one .nc file it sees I get a 0040 error, what should I try.

3)On the Boss 8 It says load and gives me a choice of selecting DNC and when I push EXECUTE the Boss  puts an asterisk after the DNC. Should I see a response on the computer running DNC? At the bottom of the DNC program I see data being loaded but shouldn't the mill start doing something? I just get the ERROR message.

4) I have a 12,000 character limit on the machine, is the DNC limited by that?
Steve

I have a Bridgeport Boss 8 and I want to run a program larger than the memory I have on the machine. Can someone direct me to a step by step button by button description of how to do this. I have downloaded the DNC software but I am having a bit of difficulty getting it to load a file to run. I presently load files through port A using the EDIT function of the machine.
Steve