I have attached the backup file to my message above.
- Welcome to AGG Software Forums.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Data loggers and plug-ins / Re: Date/Time Stamp not being written to file
May 21, 2009, 03:25:03 PM #2
Data loggers and plug-ins / Date/Time Stamp not being written to file
May 20, 2009, 03:12:21 PM
Hello,
When using Serial Printer Logger Standard, on my test machine I was able to set it up so a date/time stamp was written to the file before writing data.
I then Created a configuration backup, and restored on the production computer, to make sure the settings were the same. But even though the box 'Write date/time stamp to file before writing data' is checked, the date/time stamp does not get written to the production's computer's file (the data is written, just not the date/time stamp as the first line).
Could someone point me in the right direction on some things I can check to make sure this is working like it should?
thanks,
Doug
When using Serial Printer Logger Standard, on my test machine I was able to set it up so a date/time stamp was written to the file before writing data.
I then Created a configuration backup, and restored on the production computer, to make sure the settings were the same. But even though the box 'Write date/time stamp to file before writing data' is checked, the date/time stamp does not get written to the production's computer's file (the data is written, just not the date/time stamp as the first line).
Could someone point me in the right direction on some things I can check to make sure this is working like it should?
thanks,
Doug
Pages1