Got the regular expression worked out

Now i am getting an 087 buffer overflow alarm on fanuc

I have got my fanuc O-T controller to communicate both ways manually and can send a file from fanuc to pc in server mode and put it in the right place. But i need to know how to format my 8888 program to get files from the server.  My O-T has no option to use brackets

Sorry wrote error wrong

UART Receiver framing error

paste from log file

2 18/07/11 09:41:58 [Mazak - 6G] Ready!
2 18/07/11 09:41:58 [Mazak - 6G] Waiting for the start of a file
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
2 18/07/11 09:42:02 [Mazak - 6G] Ready!
2 18/07/11 09:42:02 [Mazak - 6G] Waiting for the end of a file
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:02 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:03 [Mazak - 6G] UART receiver framing error
1 18/07/11 09:42:03 [Mazak - 6G] UART receiver framing error
2 18/07/11 09:42:03 [Mazak - 6G] Ready!
2 18/07/11 09:42:03 [Mazak - 6G] The file  has been successfully received
2 18/07/11 09:42:03 [Mazak - 6G] Saving data to file [C:\CNC Programs\Mazak 6G\Recieve\0133.TXT]

Machine  to pc

Mazak 6g with Mazatrol EIA dash controller.

I am receiving the files to the PC ok but I get the above error at the begining of the transmission.

Mazak coms settings

Code ISO
Stop bits 2
Check parity even
Parity check off
baud rate 4800

Settings in software

7 bits
no parity chech
2 stopbits
4800 baud

Is this a problem i need to fix

Also is this normal

The status line on the bottom is cycling through these things every 5 seconds

Waiting NC commands
Waiting NC commands
Waiting for the transmitter ready
Ready!
Waiting for the start of the file
and then in red
Can't receive a sigh of the start of a file

And round it goes again,

Hello

I have a machine with a FANUC OT controller. I cannot use brackets as that option on this machine is not turned on.

when i send a file from the NC to the PC the PC responds but then hangs with the message along the bottom.

Waiting for end of file.

Please what am i missing

Malcolm